Vanguard Steel Fire rated Doors are mainly used on fire egress area within a building complying with the building regulation and code. By installing a Steel Fire Door, one makes sure that any person inside a building under fire can escape through the designated fire door in that egress path. Also the Fire Fighters or marshals can enter the building under fire through the fire doors which will reduce the fire calamities on building and human life. Fire ratings are provided in minutes for fire door from which desired ratings can be selected according to the building regulations.

Specifications:

Steel Frames:

Frames are constructed of 1.2mm (18 gauge) or 1.5mm (16 gauge) or 2mm (14 gauge) or 2.5mm (12 gauge) commercial quality cold rolled steel ASTM A366 or hot dip galvanized steel sheet. All bends shall be formed with a true sharp radius.

Steel Shutters:

45mm (13/4") thick full flush construction with the details confirming to SDI-111A-EDGE considered. Manufactured from cold rolled steel sheets to ASTM A366 or from galvanized steel to ASTM A526. Available in nominal 1.2mm (18ga.) or 1.5mm (16ga.). Vertical edges are interlocked. 1.5mm (16ga.) deep end channels at top and bottom of door for lasting integrity. Hardware reinforcing in accordance to ANSI, SDI, NFPA standards requirements. Tested according to UL10(B) and labeled up to 2 hours. Available with wide range of glass light and louver preparations. Fire rated, Labeled: Available in sizes up to 4'x8' single and 8'x8' double. larger sizes are also available with oversize certification.

Ironmongery:

BS standard Ironmongeries will be used for all standard steel doors. ANSI standard ironmongeries can also be provided as per requirements. All concealed cutouts on frames and shutters will be made from factory. Standard Steel Door will be with 3 or 4nos. Stainless Steel Butt Hinges, Mortise Lockset, Euro profile Double Cylinder, SS Lever Handle, Door Closer, Door Stopper and Weather Strips. Ironmongery will be supplied separately along with doors and frames. Installation Manual will be provided along with each ironmongery item.

Ral Color & Finish:

All Steel doors are electrostatically factory powder coated in oven under high temperature. 70 to 80 microns will be the standard coating thickness used. On special request, Vanguard can provide up to 150 microns also as per the project requirements. Texture and Smooth finish can be made on Steel doors as per request. Internationally used Ral color codes are being followed by Vanguard Steel Doors. Ral color chart can be provided on request.